Standard installation (Domestic only) From Only £650 + VAT

4

We are OLEV approved
We are Part P registered installers
We are CHAS accredited
All work is under a 3 year warranty and will comply with current regulations - Electrical Installation requirements BS7671

Standard installation includes the following.

  • MCB into existing consumer unit
  • Up to 8m of cabling - All cabling clipped direct. We are happy to bury cable in soft ground, but additional costs will incur if breaking up concrete, paving etc
  • Rolec EV Home charge unit
    • 3.6 KwH (16 amp) for £650 +VAT
    • 7 KwH (32 amp) for £675 +VAT
  • O PEN LNE disconnector. This is a device which disconnects the charging point/s from the live conductors of the supply and the protective earth within 5 seconds in the event of a broken neutral. regulation 543.3.3.101(ii).

There are very specific requirements for EV Charge points
The electrical regulations state that..

1. "The final circuit supplying an electric vehicle charging point shall not include a PEN conductor" (combined neutral and protective conductor or TNCS system)

Regulation 722.312.2.1 Electrical installation requirements BS7671:2018

.
Most properties in the UK adopt this system of electrical protection. To enable connection to this system we install a Matt:e O PEN Disconnector which disconnects the charging point/s from the live conductors of the supply and the protective earth within 5 seconds in the event of a broken neutral regulation 543.3.3.101(ii).
We install as standard

"Every charging point shall be individually protected by a Type A, 30mA RCD"
Regulation 722.531.2 Electrical installation requirements BS7671:2018

We Install as standard
"A means of isolating the electric vehicle charging equipment circuit shall be provided"
Regulation 537.2 Electrical installation requirements BS7671:2018

We install as standard
. .